(2) Pinch rollers, in arm assembly. #10 (new) condition.
Transformer #NTK94243 and # PN-ETP1003A. #9 condition.
Contact us about similar items or replacement parts.
Cassette assembly #0390629. Not a functioning assembly, No motor, No pinch roller, (1) idler good, No tape head, Unit for springs Mechanical and cosmetic parts may need simple cleaning of belts before using. ($30), 3 Belts good, used ($12) `.
Bic T-2 cassette deck with no face plate or cover. Good for meters, transformer, motor, heads, IC's, controls, counter, etc., all in good condition.
All motors are tested for torque and oiled where required. We have prepared years ago to find and salvage parts to help repair nice older equipment. If you have a motor number not listed, show us a nice clear picture and direction of spin. You may also be required to swap your motor pulley. Plastic pulleys slide right off and back on to the new motor. Metal pulleys may require a hot soldering iron on axle to melt glue, then pull off metal pulley and install on axle at same height. PLEASE NOTE THAT SHIPPING INTERNATIONALLY WILL BE A MINIMUM OF $16 EVEN FOR SMALL PARTS.
Transport assembly, with counter mechanism, with motor #CL86M20A. Needs new belts. Meters and door are included. #9 condition
circuit in a small 1 inch cube, usually 100 KHz, we have many variations available, most new, some use. Also used in TEAC, Dokorder, Pioneer, show picture of yours, maybe we have match, (many oscillators can be used if the "legs fit" they often will operate correctly, although you may require to reset the the record bias.) various numbers on cans are "C2210001", "22132530", "1810110", "NOB008", "13775202", "TEAC52922", "92132522", #8+ condition
All parts intact. Low use. Belts are all good #9 condition. This machine has seen very little use but may need cleaning upon install. 9.
Cleaning cassette device and fluid.
Excellent low use condition.
Re: International Shipping: We ship internationally often and have yet to encounter a problem or complaint. We are very careful to test the equipment before it’s packed and then to double box the machine with added protection when needed for front panels, etc. We are not amateurs or an ebay store; we know these machines very well and know what it takes to get them to you safely. We use USPS priority internationally which seems to be the cheapest. If you prefer another carrier (you should know who delivers to your area reliably) please let us know. Also please be aware of any tariffs that you may be responsible for upon pick up on your end. International shipping may be expensive but we will make sure it is not a headache on top of the cost. PLEASE NOTE THAT SHIPPING INTERNATIONALLY WILL BE A MINIMUM OF $16 EVEN FOR SMALL PARTS.
with fluid and case. Very sophisticated cleaning system for pinch rollers and heads, great for car decks.
ADAT Parts machine. Machines appear to have Head IC amp failure. RF head is perfect. Low use otherwise. All other mechanics and electronics are perfect. #8
For boards, cosmetic parts. Appears to have bad head amp. Low switch lens. Head, mech all look clean
Unit has low use hours, but has defective RF head IC. We can sell whole or break for parts.
Power supply good. ASIC boards good. Apears to have one side of head IC dead. Unit in near perfect condition otherwise.
ADAT load mot. RF-370C-15370. With belt and pulley. Salvage Test. #9 condition.
Please be aware there is a minimum $4-$6 to ship any part. International orders will be $14-$16 to ship for anything larger than an envelope. Shipping costs are non negotiable, so please, PLEASE do not ask for a part, or for us to search for, or quantify a part if you cannot pay for the shipping.
For drive idler. JPA-1B07. Condition 9. Like New.
Part #09-40-1180 REVA PTC-1V-094V-0. Five pieces available. New.
Special preamp, RF head amp IC board.
Glass ferrite head. Used in excellent condition.
Cassette deck meter, very good #8.5 condition.
We have been selling and repairing professional and consumer audio equipment for over 40 years. (Read some of our customers testimonials here).
Single Cassette Recorder, motor EG-510-2B2. Unit looks very low use. Needs belts (look like common belts) Motor is good. Needs some what complex take apart Level 2 tech required. #7 condition.
Boards: logic, power. T2030 B502A. With IC's: LM6402H, BA6109, LC7800, 6458S, LC7800, UPC1043C. ($24), Main Board T2029A501A 4ED. With parts: HA12038. Omron LAB2NS Relay. ($22), Other parts available: controls etc., Servo motor board w/ coils M3103C726A ($18), Face LCD board T2030B5030 ($22). 9