Stereo cassette deck good for parts, or can be repaired upon request.
Boards: logic, power. T2030 B502A. With IC's: LM6402H, BA6109, LC7800, 6458S, LC7800, UPC1043C. ($24), Main Board T2029A501A 4ED. With parts: HA12038. Omron LAB2NS Relay. ($22), Other parts available: controls etc., Servo motor board w/ coils M3103C726A ($18), Face LCD board T2030B5030 ($22). 9
Single Cassette Recorder, motor EG-510-2B2. Unit looks very low use. Needs belts (look like common belts) Motor is good. Needs some what complex take apart Level 2 tech required. #7 condition.
Cassette deck meter, very good #8.5 condition.
Please be aware there is a minimum $4-$6 to ship any part. International orders will be $14-$16 to ship for anything larger than an envelope. Shipping costs are non negotiable, so please, PLEASE do not ask for a part, or for us to search for, or quantify a part if you cannot pay for the shipping.
Glass ferrite head. Used in excellent condition.
Special preamp, RF head amp IC board.
Part #09-40-1180 REVA PTC-1V-094V-0. Five pieces available. New.
For drive idler. JPA-1B07. Condition 9. Like New.
ADAT load mot. RF-370C-15370. With belt and pulley. Salvage Test. #9 condition.
Customers outside of the US, please note that international shipping can be costly (US Post $16 minimum - up to 8oz or 226g). We are glad to combine orders to reduce shipping costs. Take a look at our shipping policies for more information and estimates of prices and shipping time.
Power supply good. ASIC boards good. Apears to have one side of head IC dead. Unit in near perfect condition otherwise.
For boards, cosmetic parts. Appears to have bad head amp. Low switch lens. Head, mech all look clean
Unit has low use hours, but has defective RF head IC. We can sell whole or break for parts.
ADAT Parts machine. Machines appear to have Head IC amp failure. RF head is perfect. Low use otherwise. All other mechanics and electronics are perfect. #8
with fluid and case. Very sophisticated cleaning system for pinch rollers and heads, great for car decks.
Excellent low use condition.
We offer expert time-saving advice on repairing many types of home and studio equipment, as well as consulting for product and recording issues, at a fair and reasonable cost. For complex matters, we sometimes must charge a small technical fee. If we can help solve your repair problem or technical conundrum, give us a call. (617)926-8020.
Cleaning cassette device and fluid.
All parts intact. Low use. Belts are all good #9 condition. This machine has seen very little use but may need cleaning upon install. 9.
circuit in a small 1 inch cube, usually 100 KHz, we have many variations available, most new, some use. Also used in TEAC, Dokorder, Pioneer, show picture of yours, maybe we have match, (many oscillators can be used if the "legs fit" they often will operate correctly, although you may require to reset the the record bias.) various numbers on cans are "C2210001", "22132530", "1810110", "NOB008", "13775202", "TEAC52922", "92132522", #8+ condition
Transport assembly, with counter mechanism, with motor #CL86M20A. Needs new belts. Meters and door are included. #9 condition
Bic T-2 cassette deck with no face plate or cover. Good for meters, transformer, motor, heads, IC's, controls, counter, etc., all in good condition.
All motors are tested for torque and oiled where required. We have prepared years ago to find and salvage parts to help repair nice older equipment. If you have a motor number not listed, show us a nice clear picture and direction of spin. You may also be required to swap your motor pulley. Plastic pulleys slide right off and back on to the new motor. Metal pulleys may require a hot soldering iron on axle to melt glue, then pull off metal pulley and install on axle at same height. PLEASE NOTE THAT SHIPPING INTERNATIONALLY WILL BE A MINIMUM OF $16 EVEN FOR SMALL PARTS.
Aux in mini switch, 12 pin connect. #10 (new) condition.
(2) Pinch rollers, in arm assembly. #10 (new) condition.