Black with white lettering, black anodized, all lettering intact *except (L-R) "L" slightly rubbed and discoloration of black surface, this face panel can use previous screws standard to regular face, very good, still shows nicely, Condition #9+
Black with white lettering, black anodized, all lettering intact, very slight discoloration of surface below lower right side screw hole, looks very nice, excellent condition, Condition #9
Black with white lettering, black anodized, all lettering intact, very light, small scratch below center screw very light about 2" long, this face can use previous screws standard to regular face, very good condition, shows well, Condition #9-
Gray, All lettering intact, this face can use previous screws standard to regular face, very slight bend upper left hand corner, used, Condition #8+
Contact us about similar items or replacement parts.
(1) MC Board (MC PreAmp), allows moving coil cartridge to be used in Apt Holman Pre-Amp. MUST BE INSTALLED. 100 ohm impedance, used - very good #9 condition
Contact us about similar items or replacement parts.
Re: International Shipping: We ship internationally often and have yet to encounter a problem or complaint. We are very careful to test the equipment before it’s packed and then to double box the machine with added protection when needed for front panels, etc. We are not amateurs or an ebay store; we know these machines very well and know what it takes to get them to you safely. We use USPS priority internationally which seems to be the cheapest. If you prefer another carrier (you should know who delivers to your area reliably) please let us know. Also please be aware of any tariffs that you may be responsible for upon pick up on your end. International shipping may be expensive but we will make sure it is not a headache on top of the cost. PLEASE NOTE THAT SHIPPING INTERNATIONALLY WILL BE A MINIMUM OF $16 EVEN FOR SMALL PARTS.
Special kit of black, anodized knobs with a shiny finish. 4 small, 2 large. Unique, custom set for prototype audiophile version. For in house use, requires special fit onto shafts. Very sexy! Like new! Condition 9+
Knob kit. 2 large, 4 small. Matte black quasi anodized paint. Nice #9+ condition.
Contact us about similar items or replacement parts.
Appears to be the same part for either AM10 or MX10. Three position switch with two sets of contacts.
Rackmount faceplate, lettering good but faceplate has lost black anodization and turned purple, no scratches, #7
120vAC transformer for ADA MB-1. Excellent condition.
Contact us about similar items or replacement parts.
